System Configuration 2-7Maxtor EIDE Hard Drive Jumper SettingsThe factory settings for the jumpers on the Maxtor EIDE Ultra DMA/66 hard drive are shown inthe following table. The settings are for a single hard drive installed in the system as the masterdevice. Specifications for the hard drive are included in Section 9.Maxtor EIDE Hard Drive Jumper SettingsFunction Jumper Pins DescriptionMaster Device J50-1, J50-2J48-2, J46-2Sets hard drive as masterdevice in single drive system.Factory setting: J50 pins 1and 2 jumpered; J48 pin 2and J46 pin 2 jumpered.Slave Device J48-2, J46-2J44-2, J42-2Sets hard drive as slave. Notused.Cable Select(CSEL)J48-1, J48-2J44-2, J42-2Not used.Cylinder Limitation Not used.Quantum EIDE Hard Drive Jumper SettingsThe factory settings for the jumpers on the Quantum EIDE Ultra DMA/66 hard drive are shownin the following table. The settings are for a single hard drive installed in the system as a masterdevice. Specifications for the hard drive are included in Section 9.Quantum EIDE Hard Drive Jumper SettingsFunction Jumper Pins DescriptionMaster Device (DS) Jumpered Sets hard drive as master device in single drivesystem. Factory setting: DS pins jumpered.Slave Device Open Sets hard drive as slave.Cable Select(CS)Not used.Park (PK) Use these pins to “park” a jumper not in use.CD-ROM Drive Jumper SettingsThe type of switch or jumpers and the settings for the CD-ROM drive depend on themanufacturer’s model. The NECC factory setting is for the CD-ROM drive installed as themaster device on the secondary channel. Specifications for the CD-ROM drive are included inSection 9.
