5. Details of EXPRESSBUILDERExpress5800/R120d-1E, R120d-2E Maintenance Guide118Chapter 2 Convenient Features5.4 Configure EXPRESSBUILDER SettingsEXPRESSBUILDER Settings can be configured from Top Menu (described in Chapter 2 (5.2 Menu) - (2) TopMenu), as follows.(1) Load a driver into EXPRESSBUILDERA driver stored in removable media can be loaded. Use this function only for drivers provided by NEC.(2) Manage Internal Flash MemoryInternal Flash Memory can be managed by using commands described below.Note The below commands are not available when EXPRESSBUILDER is started fromInternal Flash Memory.a) Confirm the connection of Internal Flash MemoryChecks if Internal Flash Memory is installed and accessible.POST message is changed depending on the execution result of this command.If the connection of Internal Flash Memory is recognized, the commands b) and c) below can be executed.Connected: EXPERSSBUILDER can be started by pressing key ( Internal Flash Memoryis displayed on the screen).Not connected: EXPERSSBUILDER cannot be started by pressing key ( Internal FlashMemory is not displayed on the screen).b) Initialize Internal Flash MemoryClears the data in Internal Flash Memory and initializes (formats) it.Be careful that all data in Internal Flash Memory is deleted.c) Update Internal Flash MemoryCopies EXPRESSBUILDER from EXPRESSBUILDER DVD or other media provided by NEC to InternalFlash Memory.The data is overwritten and all previous data is cleared.Tips The parameter file and RAID configuration data are retained.
