NEC S2900 User Manual

Contents

NEC S2900 User Manual Manual pdf 21 page image

4 Do not allow cables connected to the disk array unit to become crimped. Ifso, a fault or fire may occur. Use only NEC approved cables for those connected to the disk array unitand check the destinations to which the cables are connected. In addition,always lock power cords and FC cables when they are connected. Use a power source independent from televisions or radios. Otherwise,interference may be generated. To connect a cable to the mating connector, make sure that the connectorof the cable is not damaged and any pins are not bent. Using a cable notapproved by NEC or a damaged cable may cause fire to occur. To disconnect a cable from the mating connector, always hold theconnector of the cable. Do not pull the cable itself to disconnect it.1.4 Notes on Use of the Disk Array Unit Do not let any animal (pets) or children handle the cables connected to thedisk array unit. Pulling the cable may cause the unit to fall down, resulting inpersonal injury or failure of the unit. Do not let any liquids such as water into the disk array unit. If so, you maybe electrically shocked or the unit may become defective. If liquids do enterinto the disk array unit, turn off the power and contact your salesrepresentative or maintenance engineer. If the disk array unit seems dry,remember that only a small amount of liquid remaining may cause the unitto become defective. Do not let any foreign substances such as clips and screws enter into thedisk array unit through the ventilating holes on the front or rear face. If so, afault may occur. Do not disassemble or modify the disk array unit. If so, a fault or electricalshock may occur. Also, repair of the unit will be charged regardless ofwarranty. If the disk array unit will not be used for a long period of time, disconnectthe plugs of the power cords from the AC outlets for safety. Disconnect the power plug from the outlet when a thunderstorm isapproaching. If it starts thundering before you disconnect the power plug, donot touch any part of the unit including the cables. If any failure is foundlater, contact your sales representative.