User Guide200www.nec-computers.comProblems with Express Setup■ Following message appears when you try to install Express Setup to the hard diskthat has smaller capacity than the specified partition size:“The specified partition size has exceeded the capacity of the hard disk. The setupcreated the partition at the maximum size that can be reserved on the hard disk.Setup will continue the process.”Then the system displays the OK button.- It is not an abnormal condition. Press Enter to continue the installation.■ The message “Press R to retry” can not be displayed correctly when copying thefiles from CD-ROM or checking CD-ROM:- Press R. When the message appears again even if you press R, restart theExpress Setup from the beginning. In case the same result occurred after therestart of installation, contact Maintenance Service Company and ask them tocheck the CD-ROM drive.■ Express Setup terminated and asks to input setup information.- There are some errors on the specified setup information. Follow the instructionto input the correct value. It is not necessary to cancel the installation.■ Specified to join the Domain, but the system is installed as Workgroup.- When the setup fails to join the Domain during the installation, it will install thesystem as Workgroup. Open [System] in Control Panel to specify joining theDomain.■ Entered the incorrect Product ID/CD key.- Even if you entered the incorrect Product ID/CD key, Express Setup will start.However, the setup will stop and asks you to re-enter the correct value. Also inthis case, input request will occur when rebooting after GUI setup completedduring Express Setup. If these 2 inputs are done correctly, there is no problemon Windows setup.■ Unable to specify the details of Network adapter.NvRAM access error An access to the non-volatile memory (NvRAM)has failed.The system-specific information does not existon the baseboard. Please restore the backupdata or write the data by using [SystemInformation Management] of the Off-lineMaintenance Utility. Only the authorizedpersonnel are allowed to do this operation.The system-specific information can't beacquired on the mother board.Table 18: Error Messages (Continued)Message Cause and Solution
