NEC UNIVERGE NEAX 2000 IPS Reference Manual

Also see for UNIVERGE NEAX 2000 IPS: Installation guide User guide User guide User guide Configuration guide

Contents

NEC UNIVERGE NEAX 2000 IPS Reference Manual Manual pdf 203 page image

Chapter 10 System Input/Output (I/O) InterfacesUNIVERGE NEAX 2000 IPS Request for Proposal (RFP) Reference Guide Page 10-7Issue 6 Stations can set Call Forwarding or Split Call Forwarding - All Calls, No Answer, and Busy Line tothe VMS. The system sends out incoming call information to the VMS. A call to a station that hasCall For-warding set to the VMS is automatically answered by the VMS. The MCI can control the LCD display of a Multiline Terminal for “MESSAGE” Indication. Thenumber of messages is not displayed. When the Message Waiting lamp control is activated with the MCI, the lamp control from thefollowing equipment will not be provided: From the Property Management System (PMS) From the station (by dialing the access code) From the Direct Station Selection (DSS) Console From the Hotel/Motel Attendant Console From the Hotel/Motel Front Desk Instrument From the Attendant Console Only one system should be programmed (via system programming) to control Message Waitinglamps through the CCIS network. The system controls Message Waiting lamps normally when the time interval between messages isa minimum of 350 msec. or more. When the VMS interface line does not answer, all of the messages are sent out from the I/O port ofthe MP/AP00. If the VMS is not ready for information receiving (Busy Status), the AP00 can temporarily store up to16 call records in its internal memory. If the maximum of 16 call records is stored and a 17th isgenerated, the system will write over the oldest stored record. When the RS port on the MP card isused for the data link to the VMS, the MP can store up to 15 call records. If a 16th call record isgenerated when the MP stores 15 call records, the system will write over the oldest stored record. The Voice Mail Integration (In band) feature can be combined with voice mail through the MCI in thesystem. The Voice Mail Integration (In band) feature and MCI feature can coexist in one systemand either can be selected per VMS (VMS station number) by system programming. When terminating a call with the ANI information to the VMS through the MCI, the system can sendthe ANI information to the VMS, if required. This is not available through CCIS interface.Hardware Required for MCIDescription Qty RemarksSPN-CP24-C MP (UA) 1 per system MPSPN-AP00B MRC-C (AP) 1 per system Control card for MCI NoteSPN-AP00B MRC-F (AP) 1 per system Control card for MCI NoteRS RVS-4S CA-C 1 per VMS AP00-VMS, 13.1ft (4.0m)RS NORM-4S CA-A 1 per VMS AP00-MODEM, 13.1ft (4.0m)PN-8LCAA As required Interface for VMS (with MW lamps)VMS 1 per systemMODEM As requiredNote: Only one AP00 can be mounted at on time in the system.