NEC VERSA 4000 Service Manual

Also see for VERSA 4000 BATTERY CHARGER WITH AC ADAPTER: Manual Manual Manual Manual

Contents

NEC VERSA 4000 Service Manual Manual pdf 29 page image

Section 2Setup and OperationThis section provides setup and operation information for the NEC Versa 4000 series sys-tem (including cabling, power-on verification and using Auto Setup).UNPACKING THE SYSTEMFind an area away from devices that generate strong magnetic fields (electric motors,transformers, etc.). Place the shipping carton on a sturdy surface and carefully unpack thesystem. The carton contents include the system, AC adapter, AC power cord, battery, soft-ware diskettes, and user documentation.HARDWARE SETUPWhen connecting power and signal cables, do the following.1. Make sure that the system is powered off.The power switch turns the system on or off. Slide the switch right to turn it on,slide the switch again to turn it off.2. Observe connector alignment marks and keys (when present).3. Connect the AC adapter cable to the power connector port as shown in FigureSection 2-8.4. Connect the end of the power cord to the AC input connector on the AC adapter.5. Connect the other end of the power cord to an AC power source.NOTE: If operating the system on DC power,verify that the system has a charged battery packinstalled. For information on connecting the ACadapter to recharge the battery pack during orafter use, see “Recharging the Battery Pack” inthe following section.6. Ensure that all connections are properly seated and secure.7. When removing or replacing cables, grasp and pull gently on the attached con-nectors.