NEC VT37 User Manual
Also see for VT37: Supplementary guideControl commandsControl commandsSpecificationsInstallation guide
                                                                           | |
Contents
| 
16AUDIO INL RAUDIO OUTL RComponentY Cb CrAC INPC CONTROLS-VIDEO INVIDEO IN COMPUTER INAUDIOL/MONO R AUDIOCOMPUTER INAUDIO2. Installation and ConnectionsYou can connect your projector to a DVD player with component output or Video output. To do so, simply:1. Turn off the power to your projector and DVD player.2. If your DVD player has the component video (Y,Cb,Cr) output, use a commercially available component video cable(RCA3) and the optional 15-pin-to-RCA (female)3 cable to connect your DVD player to the COMPUTER INconnector on the projector.For a DVD player without component video (Y,Cb,Cr) output, use common RCA cables (not provided) to connect acomposite VIDEO output of the DVD player to the Video Input of the projector.3. Connect the supplied power cable. See page 18.4. Turn on the projector and DVD player.A component signal will be automatically displayed. If not, from the menu, select [Advanced] → [Signal Select] →[Computer], and then place a check mark in the Component radio button.NOTE: Refer to your DVD player's owner's manual for more information about your DVD player's video output requirements.Connecting Your DVD Player with Component OutputDVD playerAudio EquipmentAudio cable (not supplied)Optional 15-pin - to - RCA (female)3 cable (ADP-CV1)Component video RCA3cable (not supplied) |
Related manuals for NEC VT37
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine