192. Installation and ConnectionsConnecting the Supplied Power CableConnect the supplied power cable to the projector.First connect the supplied power cable's two-pin plug to the AC IN of the projector, and then connect the other plug ofthe supplied power cable in the wall outlet.CAUTION:Do not try to touch the ventilation outlet on the left front (when seen from the front) as it can become heated whilethe projector is turned on and immediately after the projector is turned off.CAUTION:Do not turn off the AC power by pressing the main power switch or by unplugging the power cable when theprojector is powered on. Doing so can cause damage to the projector.TIP: The projector can be turned off (by either the main power switch or by unplugging the power cable)during its cool down period after it is turned off using the remote control or via the power button on the control panel.FOCUSMENUSELECTLAMPSTATUSPOWERON/STAND BY SOURCEAUTO ADJ.ENTEREXITZOOMMake sure that the prongs are fully inserted into boththe AC IN and the wall outlet.To wall outlet ←
