NEC Australia Pty Ltd Xen Master & Xen Axis2 - 22 System SpecificationsA6-324000-642-01 – Release 4.0May 2001SECTION 4SYSTEMR EQUIREMENTS ANDSPECIFICATIONS4.1 Cabling Requirements and SpecificationsThe KSU is connected with each of the Multiline Terminals andSingle Line Telephones by a separate twisted 1-pair cable or 2-paircable (only for Multiline Terminals). Refer to Table 2-3 MultilineTerminal Loop Resistance and Cable Length, Table 2-4 CableConnection between an Analogue Interface and a Single LineTelephone, and Table 2-5 Cabling Requirements.Table 2-3 Multiline Terminal Loop Resistance and Cable LengthTerminal or AdapterMaximumLoopResistance(Ohms)MaximumMetres byTwisted 1-PairCableMaximumMetres byTwisted 2-PairCable24 AWG 24 AWGDTU-8-1 (WH) TEL 35 180 300DTU-16D-1 (WH) TEL 26 135 270DTU-32D-1 (WH) TEL 21 110 215DCU-60-1 (WH) Console N/A 300 300SLT(1)-U13 ADP 35 180 300ETW-8-1 (SW) TEL 36 180 300ETW-16C-1 (SW) TEL 26 135 270ETW-16D-1 (SW) TEL 21 110 215ETW-24S-1 (SW) TEL 26 135 270EDW-48-2 (SW) Consolewith AC Adapter N/A 300 300Note 1: When installing an Attendant Console, an AC Adapter is required.Note 2: The length for the specified SLT Adapter is the length betweenthe SLT Adapter and the ESI.Note 3: ETW and EDW-type terminals are not available in New Zealand.
