NEC Australia Pty Ltd Xen Master & Xen Axis3 - 38 Hardware RequirementsA6-324000-642-01 – Release 4.0May 2001SECTION 5PROGRAMMING FROMA M ULTILINE TERMINALProgramming for the Xen System is accomplished through PCProgramming. As an added convenience, programming for the system canbe accomplished using Multiline Terminals with LCD. Multiline Terminalprogramming should be used after the system is installed and any initialassignments are made. Using the Multiline Terminal provides a quick way toaccess system data and make changes to data items. To program from aMultiline Terminal one of the following terminals is required.✆ DTU-8D-1A(WH) TEL✆ DTU-16D-1A(WH) TEL✆ DTU-32D-1A(WH) TEL✆ ETW-16C-1A(SW) TEL✆ ETW-16D-1A(SW) TEL✆ ETW-24S-1A(SW) TEL# ETW-type TEL are not available in New Zealand.SECTION 6XEN M ASTER R EMOTEPC PROGRAMMINGThe Xen System can be programmed from a remote location using apersonal computer.6.1 Remote ProgrammingTo provide remote programming the following hardware is required:✆ Analogue CO Trunk or system SLT Port (not needed if theoptional internal modem is used)✆ A straight RS-232C cable and adaptor (provided with theMIFM-U13 ETU) cable to connect a locally provided modem(not needed if the optional internal modem is used)✆ MIFM-U13 ETU installed in the Xen System
