NEC i-Series Gateway Quick Installation Manual
Also see for i-Series: ManualUser guideFeature handbookQuick reference guideQuick reference guide
                      | |
i-Series Gateway Page 15 G-6000G-SKE, Rev AASetup WizardThe i-Series Gateway provides a console setup wizard that guides a user through most of the requiredprogramming/configuration required to complete initial setup of the units, via the VT100 managementconsole accessed through the DB-9 management port. You can use the MI to set parameters notconfigurable through the wizard.Access the setup wizard through the console MI, requiring a PC to connect to the unit (i-Series Gateway)via the DB-9 console port. The wizard queries the user on the basics of the particular configuration, anduses this information to establish the initial configuration programming.Standard Console UI vs. the Setup WizardWhen a unit is first powered up, it checks a Setup Wizard flag. If the flag is set, the standard console UI isdisplayed. If the flag is not set, the system asks you to run the Setup Wizard. After this initial prompt theSetup Wizard flag is set. This prevents the unit from asking you to run the Wizard again. You can alsoaccess the Setup Wizard through the console MI if you want to run it later.How to access the Setup Wizard through the MIPath: Gateway->Utilities -> Setup Wizard |
Related manuals for NEC i-Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine