NEC i-Series Gateway Quick Installation Manual
Also see for i-Series: ManualUser guideFeature handbookQuick reference guideQuick reference guide
                      | |
i-Series Gateway Page 6 G-6000G-SKE, Rev AA8rpvThe i-Series Gateway requires connections A through E as shown below.Table 2. PBXtender ConnectionsLetter Label Cable Type DescriptionA Console DB-9 Connect to a PC for administration in two ways: Direct serial connection to a PC. Connect to a modem for remote access.(See page 14 for modem installation and setup.)Note: Set the COM port as follows; Baud rate: 9600,Databits: 8, Parity: none, Stopbits: 1,Software flow control: XON/XOFFB - Power Connect to a 120VAC outlet.Connect as the last step. (See page 8.)C TelephonyInterfaceRJ 21 Wire to a punchdown block and then to the PBX.(See Table 3, page 7.)D WAN1 DB 25, serial,straight-throughUsed for a synchronous or asynchronous-serialconnection. Connect to a TA, CSU/DSU, or othernetwork device.Note: An RS-530 type cable or DB-25 to M34 cableshould be used for high-speed links to V.35 equipment.E LAN RJ 45 Ethernet Used for Telnet management or for connecting the unitto the LAN for use in Voice over IP (RVP_IP)applications.Front of UnitBack of Unit0TELEPHONY INTERFACE WAN 1 WAN 2 XMT LNKRCV CLN100-240 V ~ 0.8A 50-60 HZAB C D ELN KC LN31 2 8 9 10 11 127654PortStatusPW R 1 32C onsole W ANR eset |
Related manuals for NEC i-Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine