44 NEDXCM2085DLCT3 UME-0063-02Note： When the output signal setting2 is set in simple addition mode (vod2),the second parameter (calibration level) of the pixel correction should be setas follows.In case of voa x 0 and voa x 3, the second parameter (calibration level) of thepixel correction should be set at 100DN which is in half of digital number,because the data is increased approximately two times by the data in simpleaverage mode.In case of voa x 2, the second parameter (calibration level) of the pixelcorrection should be set at 50DN which is in quarter of digital number,because the data is increased approximately four times by the data in simpleaverage mode.The data of camera outputs is corrected at the 200DN and vicinity.4.2.22 Initializing Pixel Correction DataDeletes user arbitrary pixel correction data and resets to factory settings.All of data of analog gain reset to factory settings except for the gain setting andoffset setting of the camera setting.When the camera is shipped out, the data of factory black pixel correction andfactory white pixel correction is stored.It takes about 2 minutes to complete this command task after the commandis sent.Note： While the command task is executed, the camera does not respond for about1 minute. After that, OK comes back from the camera.Do not turn off the power supply of the camera during this execution orthe camera may be damaged. Format 1 CMD CR CMD calibdefcalibdef CR>OK>calibdef
