48 NEDXCM2085DLCT3 UME-0063-024.2.27 Setting Output Signal Readout DirectionSets the output signal readout direction according to the moving object directionand camera scan direction.This setting can be used to make the image which is the same as the object onthe aspect ratio by controlling the speed of the object moving and the exposure time.The lengthened or squashed image may make the wobble of color gap in one pixeland the staggered edges of straight line on the image.Set the value for “vod” command to 0 as the factory setting if you accept the degreeof the wobble of color gap in one pixel and the staggered edges of straight line onthe image.When objects flow from the top to the bottom and a camera is fitted so that thetripod screw is located at the bottom;Scan Direction Value for vodForward（rev 0） vod 2Reverse（rev 1） vod 1When objects flow from the bottom to the top and a camera is fitted so that thetripod screw is located at the bottom;Scan Direction Value for vodForward（rev 0） vod 4Reverse（rev 1） vod 3 Format 2 CMD□VAL1 CR CMD vod VAL1 0,1,2,3,4 (0-4 shown above)vod□1 CR (Standard)>OK
