NEFF S series Instruction Manual

Also see for S series: User manual User manual Instruction manual Instruction manual Instruction manual

NEFF S series Instruction Manual Manual pdf 33 page image

Operating the appliance en33Programme endThe programme has finished when thevalue ‹‹h:‹‹m appears in the displaywindow )". If a value has been set forthe signal volume, then the end of theprogramme is also indicated audibly bya buzzer.* The end of the programme isdisplayed on the floor – provided theTimeLight (optical display) is switchedon and is visible.Note: When Eco drying is activated, theend of the programme is not indicatedby a buzzer.* depending on the features of yourdishwasherSwitching off the applianceShortly after the end of theprogramme:1. Switch off ON/OFF switch (.2. Turn off water supply (does notapply to appliances with Aqua-Stop).3. Remove the utensils when they havecooled down.About the Eco drying function:When Eco drying is activated in theEco 50° programme, the door opensautomatically when the programmeends. This ensures the best possibledrying result. Low amounts of steammay occur. If you install the applianceunder a worktop, fit the suppliedsteam protection film * (follow theprocedures in the installationinstructions). The steam protection filmprotects sensitive fitted furniture andworktops from damage by watervapour. Before opening the appliance,leave it to cool down for a while in theremaining programmes when theprogramme ends.Interrupting the programmeCaution!Expansion (overpressure) may causethe appliance door to jump open and/orwater to escape! If the door was openedon an appliance which has a hot waterconnection or is heated, always leavethe door ajar for several minutes andthen close it.1. Switch off ON/OFF switch (.The LEDs go out. The programme issaved.2. Switch on the ON/OFF switch (again to continue the programme.Terminating the programme(Reset)Terminatingtheprogramme 1. Open the door.2. Press the START button h andhold it down for about 3 seconds.The value ‹‹h:‹‚m appears in thedisplay window )".3. Close the door. The programmesequence lasts about 1 minute.The value ‹‹h:‹‹m appears in thedisplay window )".4. Open the door.5. Switch off ON/OFF switch (.6. Close the door.Changing the programmeWhen the START button h has beenpressed, the programme cannot bechanged. The only way a programmecan be changed is by Cancelprogramme (Reset).