NEFF U17M42.3GB Instruction Manual

Contents

NEFF U17M42.3GB Instruction Manual Manual pdf 20 page image

20The hinges are secured and cannot snap closed.3. Close the appliance door until resistance becomesnoticeable (figure A)4. With both hands, grip the door on the left and right-hand side,close the door a little more and pull it out (figure B).Fitting the appliance door1. Insert the hinges in the left and right-hand holders (figure C).The notch on both hinges must engage.2. Open the appliance door fully.3. Close the locking levers on the left and right-hand side fully(figure D).The appliance door is secured and can no longer beremoved.4. Close the appliance door.Cleaning the door panelsTo facilitate cleaning, you can remove the inner door panelsfrom the appliance door.: Risk of injury!The components inside the appliance door may have sharpedges. Take care not to cut yourself. Wear protective gloves.: Risk of injury!The appliance must not be used again until the door panelsand appliance door have been correctly fitted.Removing the door panelNote: Before removing, make a note of which way round thedoor panel is fitted, so that it is not refitted the wrong wayround.1. Unhook the appliance door and lay it on a soft, clean surfacewith the front side facing downwards (see section: Removingand installing the appliance door).2. Pull off the cover at the top of the appliance door. Press inthe tabs on the left and right using your fingers (fig.A).3. Lift the door panel slightly and pull it out (Fig. B).Removing the intermediate panelLift the intermediate panel slightly and pull it out towards you.CleaningClean the door panel with glass cleaner and a soft cloth.: Risk of injury!Scratched glass in the appliance door may develop into acrack. Do not use a glass scraper, sharp or abrasive cleaningaids or detergents.Fitting the intermediate panelNote: During installation, make sure that the lettering "top right"is upside down at the bottom left.Insert the intermediate panel towards the back as far as it willgo.Fitting the door panel1. Insert the door panel at an angle towards the back into bothbrackets as far as it will go. The smooth surface must faceoutwards.