NAVIGUIDE 4000 056336 Rev. AA4.4: DC Daughter PCB Jumper Settings Page 4–54.4 DC Daughter PCB Jumper SettingsThe daughter PCBs are installed on the main PCB in the locations indicated inFig.4–4. If DC Solenoid Daugther PCBs are installed, jumpers must be set to con-figure the PCBs for the required switching mode (source or sink configuration).Table 4–2:DC daughterPCB jumpersettingsFig. 4–5:location ofjumpers on theDC solenoiddaughter PCBJumper SettingsSink configuration(minus switched)E2-E3, E5-E6, E8-E9, E11-E12Source configuration(plus switched)E1-E2, E4-E5, E7-E8, E10-E11
