NST FULL D1 DVR User Manual
                                                                                  | |
Contents
| 
CONNECTION AND SETUP52.2 Camera ConnectionInstall the camera on the wall or ceiling based on your installation environment and camera type. For installationdetails, please refer to the user manual of your camera.2.2.1 Normal / DCCS Camera1) Connecting to DVR video inputConnect the camera video output to the DVR video input port with a coaxial cable or RCA line with a BNCconnector.Note: For connecting a DCCS-type camera, make sure your DVR model supports DCCS, the camera isconnected to the 1st video channel (CH1), and the distance between the camera and DVR needsto be within 200 meters by using a 3C2V coaxial cable (112 braids) for DCCS control to takeeffects. For more details, please refer to “2.8 Examining DCCS Signal Transmission” at page 9.2) Connecting to DVR audio input (Optional)Connect the camera audio output to the DVR audio input port with a coaxial cable or RCA cable with BNCconnectors.3) Connecting to powerConnect the camera with indicated power supply and make sure it’s power-supplied.2.2.2 PTZ CameraThe following description is taking our brand’s PTZ camera as an example.Note: The RS485 wiring is not needed when your DVR and PTZ camera both support DCCS, and thevideo channel your PTZ camera connects is CH1. If yes, please go to STEP 5 directly for PTZcamera setting.For detailed PIN / port connection, please refer to “APPENDIX 2 PIN CONFIGURATION” at page 64. For detailedPTZ camera control and operation, please refer to its own user manual.RJ11 cable 25 PIN D-Sub ConnectorRS485-A: Red wire RS485-A: PIN 12RS485-B: Green wire RS485-B: PIN 2411516171819202122232425 142345678910111213Solder Side of25-pin D-Sub connectorRS485 -A: PIN12 / RS485-B: PIN2 4The RJ11 cable is not supplied in the sales package. The D-Sub connector is not supplied with the DVR package.STEP 1: Get a RJ11 cable with the proper length to your connection.Different RJ11 connector may have different wire layout, so the connection might be different. If youcannot control the DVR after connection, please reverse the RJ11 cable connection with the DVR.STEP 2: Remove one end of the insulating coating of the RJ11 cable.Remove one end of the insulating coating of the RJ11 cable to find the RS485-A and the RS485-B wires,and remove the insulating coating to reveal the naked wires for further connection. |
Related manuals for NST FULL D1 DVR
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine