NST FULL D1 DVR User Manual
                                                                                  | |
Contents
| 
APPENDIX 9 DVR BATTERY REPLACEMENT76APPENDIX 9 DVR BATTERY REPLACEMENTDVR time reset after power failure, for example, caused by a power outage, will cause the disorder of the recorded data,and users may have problems in searching the event clip they want. To keep the DVR time from resetting, anon-chargeable lithium battery, CR2032, is installed in the DVR.However, the DVR time might still get reset when the DVR battery is low or even running out of power. If so, pleasereplace the DVR battery, CR2032, right away as instructed below. How to replace CR2032Note: The lithium battery, CR2032, is a non-chargeable battery, and should be purchased separately.Please replace only with the same or equivalent type battery in case of danger.Step1: Stop all DVR recording immediately to prevent the disorder of the recorded data. Then, back up therecorded data if necessary.Step2: Power off the DVR, and disconnect the DVR power.Step3: Remove the DVR cover, and find the battery on the mainboard.Step4: Push the release as indicated below to remove the battery.Step5: Get a new battery with the side of “CR2032” facing up, and install it to the mainboard.Step6: Replace the DVR cover and connect to power.Step7: Set DVR date & time, and resume recording. For details, please refer to “2.5 Date and Time Setting” at page7, and “5.4.6 RECORD” at page 35. |
Related manuals for NST FULL D1 DVR
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine