NST FULL D1 DVR User Manual

Contents

NST FULL D1 DVR User Manual Manual pdf 11 page image

CONNECTION AND SETUP6STEP 3: Twist the RS485-A and RS485-B wires of the RJ11 cable and the speed dome camera together.Twist the RS485-A (red) and RS485-B (green) wires of the RJ11 cable to the RS485-A (brown) andRS485-B (orange) wires of the speed dome camera. To protect the naked wires, use the insulation tapeto cover on the twisted wires.STEP 4: Connect the other end of the RJ11 cable to DVR.Solder the RS485-A (red) and RS485-B (green) wires of the RJ11 cable to the corresponding pins on thesolder side of the 9 or 25 PIN D-Sub connector (as shown above).STEP 5: Set the camera at the DVR side.Right click to show the main menu in the live view, and go to “ ” (ADVANCED CONFIG)  “DEVICES”to set the camera.a) Select the device to “PTZ”.b) Set the ID to the value the same as the one set in the camera. The default ID of the camera is 000.c) Select the protocol to “NORMAL”.d) Set the baud rate to the value the same as the one set in the camera. The default baud rate of thecamera is 2400.ADVANCED CONFIGCAMERA CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11  DETECTION DEVICE PTZ ALERT ID 000NETWORK PROTOCOL NORMAL DISPLAY RATE 2400 RECORDDEVICESDCCSIVSNOTIFYEXIT2.3 External Device ConnectionThis device supports external device connection with RS485 and alarm I/O ports, allowing users to connectcontrol devices such as a PTZ camera or keyboard controller, or connect alarm devices such as a magneticcontact or buzzer.Check the user manual of your external device to know which pin(s) should be used, and connect it to thecorresponding pins on the DVR rear panel.Note: For more details about alarm I/O pin configurations, please refer to “APPENDIX 2 PINCONFIGURATION” at page 64.Certain alarm-in pins also support sending instant event notifications to your mobile devices, such as iPhone, iPadand Android mobile devices, for an alarm event (Push Video). For details, please refer to “APPENDIX 3 PUSHVIDEO CONFIGURATION” at page 65.