CHAPTER 17RUN OUT TABLES AND REMOTE LIMIT SWITCH84RUN OUT TABLES AND REMOTE LIMIT SWITCHThe Run-Out Table (Figure 80 & Figure 81) attaches to the Exit End of the Shearassembly, and is used to support the panel as it exits the machine. It is available in 10 ft.long sections that fasten together, and have adjustable legs so they can be set to thecorrect height. The Remote Limit Switch (Figure 7 on page 14) is designed to be usedwith the run out tables for controlling panel length.1. Set the first Run-Out Table on its side and in front of the machine with the legassembly away from the shear.2. Open the leg assembly and set it upright on the ground.3. Lift the attachment end of the table and drop it over the 2 threaded bolts on theShear Run-Out Table Bracket.4. Loosen the 2 knob-handles on the leg assembly and allow the legs to fall free. Sightthe height of the table on the left and right side adjusting it level to the machineusing the knob-handles to lock the legs in place. See Figure 81 for correct andincorrect set up and details.5. Repeat the above procedures for each succeeding table and attach it to the bracketon the end of the previous table.
