CHAPTER 19TROUBLESHOOTING91Figure 84: Limit Switch Adjustment4. After making a cut, the male or female leg of the next panel gets caught on theexit shear die and damages the panel.SOLUTION: This problem normally shows up after making a roller system/sheardie change. The entry dies both male and female should be as close to thevertical leg of the panel as possible without touching. Once this isachieved, the exit die should be set just outside the vertical leg of the entrydie so that as the fresh cut edge of the panel passes by the exit die itdoesn’t getting caught (Figure 58 on page 62).5. The male and or female leg gets crushed when shearing.SOLUTION #1: Check the Shear Blades directly over the male and female legsto make sure that the points of the blades are in the correct position(Figure 19 & Figure 20 on page 31).
