Nanoptix EZ-Tear Owner's Manual
Also see for EZ-Tear: Cleaning instructions
                     | |
Contents
| 
EZ-Tear Thermal PrinterOwner’s Manual1.6 Changing PaperCaution: Do not operate the printer if it runs out of paper. The printer will not operatewithout paper, but it may continue to accept data from the host computer. Because theprinter cannot print any transactions, the data may be lost.1. Open the top cover by pulling under the tab on both sides.2. Remove the used roll.3. Tear off the end of the new roll so that the edge is loose and place the new roll intothe spindle bracket with a few inches of loose paper at the bottom of the roll.Figure 5: Loading PaperCaution: The tear blade has sharp corners and caution should be exercised whenloading paper not to cause personal injury.Notice: Be sure the paper unrolls from the bottom. Otherwise, the printer will notPrint.OptionalSpindle bracketAlignmentTabs102136July, 2005 6 |
Related manuals for Nanoptix EZ-Tear
Nanoptix EZ-Load Owner's Manual
Nanoptix DSP-HPQ Owner's Manual
Nanoptix CALLISTO Owner's Manual
Nanoptix CALLISTO Owner's Manual
Nanoptix Paycheck 2 Owner's Manual
Nanoptix PayCheck 4 Owner's Manual
Nanoptix PAYCHEK SLIM Owner's Manual
Nanoptix Suzohapp HSV Owner's Manual
Nanoptix Orizon NextGen Owner's Manual
Nanoptix HSVL ADVANCED Owner's Manual
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine