W415-1793 / A / 05.07.18EN40finishing10.8 glowing embers10.9 charcoal embers22.2Randomly place the charcoal embers along the front and sides of the log support in a realistic manner.Fine dust found in the bottom of the bag should not be used.! WARNING• Do not block or close off the burner ports. Blocked ports can cause an incorrect fl ame pattern, carbondeposits and delayed ignition.• When supplied, charcoal embers, charcoal lumps and vermiculite are not to be placed on the burner.note:Charcoal embers are not to be placed on the burner.22.1Tear the embers into pieces and loosely layer above the burner ports covering the burner area. Care should betaken to shred the embers into thin, small irregular pieces as only the exposed edges of the fibre hairs will glow.The ember material will only glow when exposed to direct fl ame; however, care should be taken to notblock off the burner ports.Blocked burner ports can cause an incorrect fl ame pattern, carbon deposits and delayed ignition. PHAZER™logs glow when exposed to direct flame. Use only certified “glowing embers” and PHAZER™ logs available fromyour local authorized dealer / distributor.! WARNING• Do not block or close off the burner ports. Blocked ports can cause an incorrect fl ame pattern, carbondeposits and delayed ignition.16.6Vertical installations may display a very active flame. If this appearance is not desirable, the vent exit mustbe restricted using a restrictor vent kit. Refer to the “replacements” section of the owner’s manual for theappropriate kit. This will reduce the velocity of the exhaust gases, slowing down the flame pattern and creating amore traditional gentle flame appearance. Specific instructions are included with the kit.This appliance has an air shutter that has been factory set open according to thechart below:Regardless of venturi orientation, closing the air shutter will cause a more yellowflame, but can lead to carbonization. Opening the air shutter will cause a moreblue flame, but can cause flame lifting from the burner ports. The flame may notappear yellow immediately; allow 15 to 30 minutes for the final flame colour to beestablished.AIR SHUTTER ADJUSTMENT MUST ONLY BE DONE BY A QUALIFIEDINSTALLER!AirShutterOpeningVenturiBurnerIt is important that the orifice is securely inserted into the venturi.note:GX70-1NG 3/8" (9.5mm)P Full OpenAn air shutter access plate has been provided for initial flame appearance setup. It becomes more difficult toadjust once the appliance has been finished.note:10.10 restricting vertical vents10.11 venturi adjustment