Napoleon BGD36CFGN-1 Installation And Operating Instructions Manual

Also see for BGD36CFGN-1: Installation and operating instructions

Contents

Napoleon BGD36CFGN-1 Installation And Operating Instructions Manual Manual pdf 28 page image

28W415-1361 / 11.28.14EN7.6AThis appliance is designed to be attached to a 3” (76.2mm) co-linear aluminum flex vent system running thefull length of a masonry chimney.The flex liners accommodate any contours of amasonry chimney, however, it is necessary to keepthe flexible liners as straight as possible. The inlet aircollar of the termination cap must be connected tothe air intake flex liner and the exhaust collar must beconnected to the exhaust flexible liner.Both Simpson Duravent and Selkirk co-linear toco-axial adaptors have been approved on thisappliance (NOTE: A vent adaptor will be requireddirectly off the appliance).Follow vent manufacturer’s installation instructions.Different manufacturer’s venting components mustnot be combined. Once the preferred manufacturer’sappliance adaptor has been attached, theremainder of the system must be that of thesame manufacturer.The only exception to this rule is to use WolfSteel’s approved 3” (76.2mm) flex liner andco-linear termination.! WARNINGRISK OF FIRE!CO-AXIAL TO CO-LINEAR VENTING CONFIGURATIONS MUST ONLY BE USED IN A NON-COMBUSTIBLE CHIMNEY OR ENCLOSURE. INSTALLATION IN A COMBUSTIBLE ENCLOSURE COULDRESULT IN A FIRE.AIRINTAKEEXHAUSTFLUEFLEXLINER* 40 FT (12.2m)MAX.10 FT (3.1m)MINCOAXIAL TOCO-LINEARADAPATORAPPLIANCEVENT ADAPTORTERMINATION* Measured from appliance flue collar totermination flue collar5.6 VERTICAL THROUGH EXISTING CHIMNEY