Napoleon BGD90NT Operating Instructions Manual

Contents

Napoleon BGD90NT Operating Instructions Manual Manual pdf 41 page image

41W415-0826 / C / 07.11.119.12 IN THE EVENT OF A POWER FAILUREIf the receiver is equipped with batteries they will enable flame height control, ON/OFF or thermostatfunction to control the fireplace during a power failure. Refer to “APPLIANCE OPERATION” section whencommunications between receiver and transmitter have been lost. The will receiver emit a “beep” sound toconfirm programming has been successful once power is restored. During a power failure, if the fireplace wason, the flame height will stay at the setting prior to the failure. If off when the failure occurs and then turned on,the flame height will come on at “HI”. The flame height can then be controlled by the remote.35.149.13 CONTROL MODULEControl module offers the added ability to control the fanspeed through six (6) speeds, a remotely actuated 120VAUX outlet for the NIGHT LIGHT™ and a constantlypowered 120V outlet.NOTE: Control module ON/OFF switch should alwaysbe in the “ON” position. If for any reason the moduleis turned “OFF”, the components plugged into themodule won’t have power.35.15CONSTANTLY POWERED120V OUTLETFAN OUTLET120V AUX OUTLETMAINS VOLTAGESUPPLY CORDMODULE ON/OFFSWITCH (SHOWN INTHE ON POSITION)COMMUNICATIONBUS (3 PIN)9.14 TIMED BLOWERYour remote system may have a built in timer (in thermostat mode) that enables the blower to cycle on andoff automatically when the burner turns on and off. With the remote control fan speed preset at the preferredspeed, the blower will come on approximately 5 minutes after the main burner comes on and will shut offapproximately 12 minutes after the burner shuts off.This time delay is designed to maximize the blower distribution of heated air.If at any time the burner re-ignites before the twelve minutes are over, the fan will continue to run.NOTE: At any time in the sequence, the blower can be manually turned on/off using the remotecontrol.35.19A