6W415-0826 / B / 07.11.11NOTE: Non-combustible fi nishing material (i.e. Cement board, brick, stone, tile) must be used to fi nishthe front of the appliance.2.3 GENERAL INFORMATIONThis appliance is approved for bathroom, bedroom and bed-sitting room installations and is certified for mobilehome installation. The natural gas model can only be installed in a mobile home that is permanently positionedon its site and fueled with natural gas.This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convert-ible for use with other gases, unless kit is used. Not external electricity (110 volts or 24 volts) is required for thegas system operation.Expansion / contraction noised during heating up and cooling down cycles are normal and are to be expected.Change in flame appearance from “HI” to “LO” is more evident in natural gas than in propane.4.1AThe installation must conform with local codes or, inabsence of local codes, the National Gas and PropaneInstallation Code CSA B149.1 in Canada, or the NationalFuel Gas Code, ANSI Z223.1 / NFPA 54 in the UnitedStates. Suitable for mobile home installation if installed inaccordance with the current standard CAN/CSA Z240MHSeries, for gas equipped mobile homes, in Canada orANSI Z223.1 and NFPA 54 in the United States.As long as the required clearance to combustibles ismaintained, the most desirable and beneficial location for an appliance is in the center of a building, therebyallowing the most efficient use of the heat created. The location of windows, doors and the traffic flow in theroom where the appliance is to be located should be considered. If possible, you should choose a locationwhere the vent will pass through the house without cutting a floor or roof joist.If the appliance is installed directly on carpeting, vinyl tile or other combustible material other than woodflooring, the appliance shall be installed on a metal or wood panel extending the full width and depth.Some appliances have optional fans or blowers. If an optional fan or blower is installed, the junction box mustbe electrically connected and grounded in accordance with local codes, use the current CSA C22.1 CanadianElectrical Code in Canada or the ANSI/NFPA 70 National Electrical code in the United States.We suggest that our gashearth products be installedand serviced by professionalswho are certified in the U.S.by the National FireplaceInstitute® (NFI) as NFI GasSpecialistswww.nficertified.orgNG LPAltitude (FT) 0-4,500 0-4,500Max. Input (BTU/HR) 50,000 50,000Max. Output Steady State (BTU/HR) 33,540 34,000Efficiency (w/the fan on) 63% 61%Min. Inlet Gas Supply Pressure 4.5" Water Column 11" Water ColumnMax. Inlet Gas Supply Pressure 7" Water Column 13" Water ColumnManifold Pressure (Under Flow Conditions) 3.5" Water Column 10" Water ColumnFOR YOUR SATISFACTION, THIS APPLIANCE HAS BEEN TEST-FIRED TO ASSURE ITS OPERATION ANDQUALITY!