46W415-0826 / B / 07.11.1112.2 GLASS / DOOR REPLACEMENTA. Place the door frame face down careful not to scratch thepaint.B. Center the gasketed glass inside the door frame with the thickside of the gasket facing up.C. Bend the glass retainers located along the edge of the doorframe over the gasket holding the glass in place. Careful notto break the glass.GLASSGASKETDOORFRAMEGLASSRETAINER! WARNINGDO NOT USE SUBSTITUTE MATERIALS.GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS ORDAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THEAPPLIANCE BEFORE OPERATION.DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASSREMOVED, CRACKED, BROKEN OR SCRATCHED.56.112.3 NIGHT LIGHT TM REPLACEMENTFIREBOX TOPNIGHTLIGHTSYour comes equipped with 2 “Night Lights™”. The lights havebeen pre-wired and is controlled from the remote control.If in the event the lamps or lens need replacing, follow these instructions.Shut off breaker at main power supply.Remove the four screws that secure the lens frame to the Firebox top.This frame retains the glass lens. The lamp can now be accessed.NOTE: Do not handle the lamp (bulb) with bare fingers, protect witha clean dry cloth.The lamp will pull straight out of the socket. Replace with Wolf Steel partsonly, as lamp and lens are special “high temperature” products.When re-installing, ensure integrity of gasket seal.THE FIREBOX MUST BE SEALED.Over tightening the screws could break the lens.“Light Leakage” from the holes in the housing lamp may be observed. Theholes in the lamp housing are necessary for ventilation and must not becovered.GASKETLENSFRAMECOLOURED SIDE UP