Napoleon BILEX485 Manual

Also see for BILEX485: Instructions Manual Manual Manual Manual

Contents

Napoleon BILEX485 Manual Manual pdf 18 page image

18www.napoleongrills.comN415-0271-AU JAN 24.18Getting Started1. Remove all cart panels, hardware, and grill head from carton. Raise lid and remove any componentspacked inside. Use the parts list to ensure all necessary parts are included.2. Do not destroy packaging until the grill has been fully assembled and operates to your satisfaction.3. Assemble the grill where it is to be used, lay down cardboard or a towel to protect parts from beinglost or damaged while assembling.4. Most stainless steel parts are supplied with a protective plastic coating that must be removedprior to using the grill. The protective coating has been removed from some of the parts during themanufacturing process and may have left behind a residue that can be perceived as scratches orblemishes. To remove the residue, vigorously wipe the stainless steel in the same direction as thegrain.5. Follow all instructions in the order that they are laid out in this manual.6. Two people are required to lift the grill head onto the assembled cart.If you have any questions about assembly or grill operation, or if there are damaged or missing partsplease call our Customer Solutions Department at 1-866-820-8686 between 9 AM and 5 PM(Eastern Standard Time).CAUTION! During unpacking and assembly we recommended you wear work gloves and safetyglasses for your protection. Although we make every effort to make the assembly process as problemfree and safe as possible, it is characteristic of fabricated steel parts that the edges and corners mightbe sharp and could cause cuts if handled incorrectly.TOOLS REQUIRED FOR ASSEMBLY (tools not included)WARNING! Construction materials and masonry dust may cause surface damage to units and accessories.The best option is to install components after all construction has been completed and the jobsite has beenthoroughly cleaned. If the components must be installed prior to the construction being completed, then exposedsurfaces need to be covered to prevent corrosion. All surfaces must be cleaned when construction is completed.Do not use muriatic acid to clean masonry materials from any surfaces. The lime contained in some constructionmaterials is extremely corrosive. During its curing period, (1 - 2 months) it is recommended that a stainless steelpolish or wax (car wax is acceptable) be applied to prevent direct contact of the lime materials.3/8” (10 mm)