Napoleon EPA 1150 Installation And Operating Instructions Manual

Also see for EPA 1100: Installation and operation instructions Installation and operation instructions Installation and operation instructions Installation and operation instructions Installation and operating instructions

Napoleon EPA 1150 Installation And Operating Instructions Manual Manual pdf 23 page image

23W415-0763 / A / 11.03.10Provisions have been made on the stove to install an optional blower kit (EP62-1) that comes complete witha variable speed switch to turn the blower on and off, as well as adjusting the blower speed. An optionalthermostatic sensor control kit, EP36, to thermally activate the blower is also available.Drywall dust will penetrate into the blower bearings, causing irreparable damage. Care must be taken toprevent drywall dust from coming into contact with the blower or its compartment. Any damage resulting fromthis condition is not covered by the warranty policy.Use of the blower increases the output of heat.Attach the mounting bracket to the blower assembly. Then attach the mounting bracket to the back of yourappliance, push on the variable speed knob and plug into any grounded electrical outlet.Do not remove the knock out on the back of the appliance.6.0 OPTIONAL KIT INSTALLATIONSA. Remove the knock-out from the back of the appliance.B. Install the blower and housing as shown using the 4screws supplied.C. Loosen the thermal switch bracket (2 screws) andslide the bracket forward until the thermodisc istouching the rear firebox and secure.See “BLOWER INSTALLATION” leaflet for detailedinstructions.123THERMAL SWITCHBRACKETSCREWSKNOCK-OUTBLOWER6.1 OPTIONAL BLOWER KIT INSTALLATION6.1.1 1150 BLOWER INSTALLATION (EP65)! WARNINGRISK OF FIRE AND ELECTRICAL SHOCK.TURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THIS APPLIANCE.USE ONLY WOLF STEEL APPROVED OPTIONAL ACCESSORIES AND REPLACEMENT PARTS WITHTHIS APPLIANCE. USING NON-LISTED ACCESSORIES (BLOWERS, DOORS, LOUVRES, TRIMS, GASCOMPONENTS, VENTING COMPONENTS, ETC.) COULD RESULT IN A SAFETY HAZARD AND WILLVOID THE WARRANTY AND CERTIFICATION.ENSURE THAT THE FAN’S POWER CORD IS NOT IN CONTACT WITH ANY SURFACE OF THEAPPLIANCE TO PREVENT ELECTRICAL SHOCK OR FIRE DAMAGE. DO NOT RUN THE POWERCORD BENEATH THE APPLIANCE.THE WIRE HARNESS PROVIDED IN THE BLOWER KIT IS A UNIVERSAL HARNESS. WHENINSTALLED, ENSURE THAT ANY EXCESS WIRE IS CONTAINED, PREVENTING IT FROM MAKINGCONTACT WITH MOVING OR HOT OBJECTS.51.5