Napoleon EPA 1150 Installation And Operating Instructions Manual

Also see for EPA 1100: Installation and operation instructions Installation and operation instructions Installation and operation instructions Installation and operation instructions Installation and operating instructions

Napoleon EPA 1150 Installation And Operating Instructions Manual Manual pdf 32 page image

32W415-0763 / A / 11.03.108.10 WOOD87.1AWhen loading the appliance, ensure that the upper fibre baffles are not forced out of position. For maximum efficiency, when theappliance is thoroughly hot, load it fully to the top of the door opening and burn at a medium low setting. The whiteness of thebricks and the cleanliness of the glass are good indicators of your operating efficiency. Not enough heat is produced when only afew pieces of wood are burned or the wood may not burn completely.Fuel for the appliance must not be stored closer than the required clearances to combustibles (heat sensitive material).NEVER STORE WOOD IN THE ASH PAN COMPARTMENT (if applicable).NOTE: When loading the appliance, ensure to keep fuel back from the glass. If coals are to accumulate on the front lip,there is a chance they will fall out when the door is opened.Burn only dry, clean unpainted wood that has been seasoned. It produces more heat and less soot or creosote. Freshly cutwood contains about 50% moisture while after proper seasoning only about 20% of the water remains. As wood is burned, thiswater boils off consuming energy that should be used in heating. The wetter the wood, the less heat is given off and the morecreosote is produced. Dry firewood has cracks in the end of the grain.Both hardwood and softwood burn equally well inthis appliance but hardwood is denser, will weighmore per cord and burn a little slower and longer.Firewood should be split, stacked in a mannerthat air can get to all parts of it and covered inearly spring to be ready for burning that fall. Dryfirewood has cracks in the end grain.Cut the wood so that it will fit horizontally, frontto back, making for easier loading and less of a likelihood that the wood will rollonto the glass.DO’S• Build a hot fire.• Use only dry wood.• Several pieces of medium sized wood are betterthan a few big pieces.• Clean chimney regularly.• Refuel frequently using medium sized wood.• “Fine Tune” the air settings for optimum perfor-mance.DONT’S• Take ash out immediately. Let it accumulate to adepth of at least one inch. A good ash layer providesfor a longer lasting and better burning fire.• Burn wet wood.• Close the door too soon or damper down too quickly.• Burn one large log rather than two or three smaller,more reasonably sized logs.• Burn at continually “low setting”, if glass door isconstantly blackened. This means the fireboxtemperature is too low.THIS APPLIANCE IS DESIGNED TO BURN NATURAL WOOD ONLY. DO NOT BURN TREATEDWOOD, COAL, CHARCOAL, COLOURED PAPER, CARDBOARD, SOLVENTS OR GARBAGE. THISAPPLIANCE HAS NOT BEEN TESTED WITH AN UNVENTED GAS LOG SET. TO REDUCE RISK OF FIREOR INJURY, DO NOT INSTALL AN UNVENTED GAS LOG SET INTO THE APPLIANCE.HIGHER EFFICIENCIES AND LOWER EMISSIONS GENERALLY RESULT WHEN BURNING AIR DRIEDSEASONED HARDWOODS, AS COMPARED TO SOFTWOODS OR TOO GREEN OR FRESHLY CUTHARDWOODS.BURNING WET UNSEASONED WOOD CAN CAUSE EXCESSIVE CREOSOTE ACCUMULATION. WHENIGNITED IT CAN CAUSE A CHIMNEY FIRE THAT MAY RESULT IN A SERIOUS HOUSE FIRE.DO NOT STORE FUEL WITHIN THE CLEARANCE TO COMBUSTIBLES, OR IN THE SPACE REQUIREDFOR RE-FUELING AND ASH REMOVAL.BURNING WET, UNSEASONED WOOD CAN CAUSE EXCESSIVE CREOSOTE ACCUMULATION. WHENIGNITED IT CAN CAUSE A CHIMNEY FIRE THAT MAY RESULT IN A SERIOUS HOUSE FIRE.