22W415-0745 / 02.16.093.2.3 FIREPLACE VENT CONNECTIONA. Install the inner flex pipe to the fireplace. Secure with 3 screwsand flat washers. Seal the joint and screw holes using the hightemperature sealant W573-0007 (not supplied).B. Install the outer flex pipe to the fireplace. Attach and seal thejoints using the high temperature sealant W573-0002 (notsupplied).2” OVERLAPHIGH TEMPERATURESEALANT#8 X 1/2”SELFDRILLINGSCREWS28.1FIGURE 3.2.3This appliance is certified to be installed as an OEM (Original Equipment Manufacturer) installation in a manufacturedhome or mobile home and must be installed in accordance with the manufacturer’s instructions and the ManufacturedHome Construction and Safety Standard, Title 24 CFR, Part 3280, in the United States or the Mobile Home Standard,CAN/CSA Z240 MH Series, in Canada. This appliance is only for use with the type(s) of gas indicated on the rating plate.A conversion kit is supplied with the mobile home appliance.This Mobile/Manufactured Home Listed appliance comes factory equipped with a means to secure the unit. The fireplace isequipped with two 1/4" diameter holes located in the front left and right corners of the base. For mobile home installations,the fireplace must be fastened in place. Use #10 hex head screws, inserted through the holes in the base to secure.Always turn off the pilot and the fuel supply at the source, prior to moving the mobile home. After moving the mobile homeand prior to lighting the fireplace, ensure that the logs are positioned correctly.This appliance is certified to be installed in an aftermarket permanently located, manufactured (mobile) home, where notprohibited by local codes.This fireplace is only for use with the type of gas indicated on the rating plate. This fireplace is not convertible for use withother gases, unless a certified kit is used.Conversion KitsThe mobile home appliance is field convertible between Natural Gas (NG) and Propane (LP).To convert from one gas to another consult your Authorized dealer/distributor.29.13.3 MOBILE HOME INSTALLATION