Napoleon LV38N Installation And Operating Instructions Manual

Also see for LV38N: Instructions

Contents

Napoleon LV38N Installation And Operating Instructions Manual Manual pdf 49 page image

49W415-1539 / A / 04.19.16ENThis function will lock the keys to avoid unsupervised operation.A. Press the MODE and UP keys at the same time.B. To de-activate this function, press the MODE and UP keys at the sametime.35.10A76°FIf the receiver is equipped with batteries they will enable flame height control or ON/OFF function to controlthe fireplace during a power failure. Refer to “APPLIANCE OPERATION” section when communicationsbetween receiver and transmitter have been lost. The receiver will emit a “beep” sound to confirmprogramming has been successful once power is restored. During a power failure, if the fireplace was on, thefl ame height will stay at the setting prior to the failure. If off when the failure occurs and then turned on, thefl ame height will come on at “HI”. The flame height can then be controlled by the remote.35.14A8.6 CONTINUOUS PILOT / INTERMITTENT PILOT (CPI / IPI) SELECTIONA. Use the Mode Key to guide you to the CPImode icon. Transmitter in the OFF position.B. Press the UP/DOWN to switch between IPIand CPI modes. A single BEEP will confirmreception of the command.Note: If the system is equipped with a CPI/IPItoggle switch, set the CPI/IPI to CPI position toenable remote CPI operation. If the switch is setto IPI then it will only work in IPI regardless ofwhat is set on the remote control handset. 35.2276 76°F °FIPI CPI8.7 CHILD PROOF FUNCTION8.8 LOW BATTERY / MANUAL BYPASS8.9 IN THE EVENT OF A POWER FAILUREThe life span of the remote batteries depends on various factors: quality of thebatteries, the number of ignitions, etc.When the transmitter batteries are low, a Battery Icon will appear on the LCDdisplay before all battery power is lost. When the batteries are replaced this iconwill disappear.When the receiver batteries are low, no “beep” will be emitted from the receiverwhen it receives an ON/OFF command. This in an alert for the receiver that there’slow battery. When the batteries are replaced the “beep” will be emitted from thereceiver when the ON/OFF key is pressed.If the batteries of the receiver or transmitter are low, the appliance can be turned on manually by sliding thethree position slider switch on the receiver to the “ON” position. This will bypass the remote control featureand the appliance main burner will come on if the gas valve is in the “ON” position.35.13A76°F