Napoleon NPS45 Installation And Operating Instructions Manual
Also see for NPI45: Installation and operating instructionsMaintenance & cleaningInstallation and operating instructions
                                                        | |
Contents
| 
W415-0702 / B / 04.04.122NOTE: Changes, other than editorial, are denoted by a vertical line in the margin.TABLE OF CONTENTS1.0 INSTALLATION OVERVIEW 31.1 STOVE 31.2 INSERT 42.0 INTRODUCTION 52.1 DIMENSIONS 62.1.1 STOVE 62.1.2 NPI45 COMPLETE WITH NI800 FLASHING 62.1.3 NPI45 COMPLETE WITH AK8 ADAPTER AND GICSK FLASHING 72.1.4 NPI45 COMPLETE WITH AK9 ADAPTER AND CISK FLASHING 82.2 SPECIFICATIONS 92.2.1 HEATING SPECIFICATIONS 92.3 GENERAL INSTRUCTIONS 92.4 GENERAL INFORMATION 102.4.1 PELLET SPECIFICATIONS 102.4.2 SAFETY FEATURES 112.4.3 EPA COMPLIANCE 112.5 RATING PLATE INFORMATION 123.0 INSTALLATION PLANNING 133.1 APPLIANCE PLACEMENT 133.2 INSTALLATION OPTIONS 133.3 STOVE MINIMUM CLEARANCE TO COMBUSTIBLES 143.3.1 STRAIGHT INSTALLATION 143.3.2 CORNER INSTALLATION 143.3.3 ALCOVE INSTALLATION REQUIREMENTS (MINIMUM) 153.4 FLOOR PROTECTION REQUIREMENTS INSTALLATION 163.5 OUTSIDE AIR 173.6 MOBILE HOME 174.0 VENTING 184.1 TYPE OF VENT 184.2 INSTALLING THE PELLET VENT 184.3 VENTING THE PELLET APPLIANCE 184.4 PELLET VENT TERMINATION 194.5 VENT TERMINAL CLEARANCES 194.5.1 HORIZONTAL EXHAUST THROUGH WALL INSTALLATION 204.5.2 THROUGH THE WALL WITH VERTICAL RISE / HORIZONTAL TERMINATION 204.5.3 MINIMUM INSIDE VERTICAL CLEARANCES 214.5.4 CLASS A CHIMNEY RETROFIT 214.5.5 HEARTH MOUNT INSTALLATION 224.6 INSERT VENTING INSTALLATION EXAMPLES 234.6.1 TYPICAL EXISTING MASONRY INSTALLATION 234.6.2 FACTORY BUILT FIREPLACE 245.0 FRAMING (INSERT ONLY) 255.1 INSTALLATION INTO A COMBUSTIBLE ENCLOSURE 265.2 MINIMUM ENCLOSURE CLEARANCES 275.3 MINIMUM CLEARANCE TO COMBUSTIBLES 275.4 MINIMUM MANTEL CLEARANCES 285.5 REAR TO TOP VENT CONVERSION INSTRUCTIONS 296.0 FINISHING 296.1 INSTALLING VIEWING DOOR 296.2 FLASHING INSTALLATION 306.3 TRIVET INSTALLATION 307.0 WIRING DIAGRAM 318.0 OPERATING INSTRUCTIONS 328.1 PROPER PELLET LOADING 328.2 START UP CYCLE 328.3 LIGHTING APPLIANCE MANUALLY 328.4 LIGHTING INSTRUCTIONS 338.5 CONTROLS 338.6 CONTROL ADJUSTMENT 348.7 INSTALLING A THERMOSTAT OR REMOTE CONTROL 358.8 SHUTDOWN INSTRUCTIONS 359.0 NORMAL OPERATING SOUNDS 3610.0 MAINTENANCE 3710.1 DAILY (WHENEVER USING THE APPLIANCE) 3710.1.1 OPENING MAIN DOOR 3710.1.2 DISPOSAL OF ASHES 3710.1.3 INSPECT THE BURN POT 3710.1.4 CARE OF PLATED PARTS 3710.1.5 CARE OF GLASS 3810.1.6 CLEANING THE HEAT EXCHANGER TUBES 3810.1.7 MAKE SURE PELLETS ARE NOT PILING UP 3810.1.8 CLEANING THE BURN POT 3910.2 BI-WEEKLY (OR EVERY 10 BAGS OF PELLETS) 39 |
Related manuals for Napoleon NPI45
manualsdatabase
Your AI-powered manual search engine