Napoleon NZ6000-1 Installation And Operating Instructions Manual

Also see for NZ6000-1: Installation and operating instructions Installation and operation manual Installation and operation instruction Installation and operating instructions

Contents

W415-1501 / 05.15.1511EN10' (3m) MIN. TOCHIMNEY CAP.NOTE: Incorporate a vertical loop or trap into airliners to reduce air flow when appliance is not inuse.Insulating the intake liners is recommended in colderclimates to prevent condensation from occurring.The Napoleon Model NZ6000-1 takes outside airdirectly into the appliance through the openings in theleft and right hand sides.Decide on the most convenient location for the freshair inlet ducts and hoods which may be installedabove or below floor level.The fresh air inlet ducts and hoods must be installed.Secure and seal the intake liners to the collars using3 sheet metal screws, and high temperature sealant.3.2 OUTSIDE COMBUSTION AIR02 (4)4 (8)6 (12)8 (16)10 (20)5(10)10(20)15(30)20(40)25(50)AIR INTAKE LINERSHORIZONTAL RUNVERTICAL RISEIncluded with the appliance are:- Two 10' (3m) lengths of vent. Use a connector and seal if addingmore length.- Two of intake hoods.The vertical height of the air intake liner must not be greater than 2/3the height of the chimney. If additional liner length is required, it may bedoubled by increasing the size from 6" (152mm) diameter to 8" (203mm)diameter. Use a 6" (152mm) to 8" (203mm) increaser at the hood anda decreaser at the appliance. Values in brackets represent 8" (203mm)diameter intake liners.The duct terminations must be located so they can not be blocked (i.e. snowdrifts). 4' (1.2m) above grade isrecommended. Make a 6 ½" (165mm) inch hole to suit in an outside wall of the house. From outside, place thefresh air hood into the hole, open side down. Seal with caulking and secure.Horizontal run may be:5' (1.5m)15' (4.6m)20' (6.1m)25' (7.6m)Vertical rise is between:6' (1.8m) & 10' (3m) max3' (0.9m) & 6' (1.8m)1' (0.3m) & 3' (0.9m)0' (0m) & 1' (0.3m)