2W415-0536 / D / 05.18.07PG2-5 INTRODUCTIONWarrantyDimensionsGeneral InstructionsGeneral InformationCare of Glass & Plated Parts5-9 VENTINGVent lengthsVenting SpecificationsAir Terminal Locations10-15 INSTALLATION/FRAMINGWall & Ceiling ProtectionUsing Flexible Vent ComponentsFireplace Vent ConnectionUsing Rigid Vent ComponentsGas InstallationRestricting Vertical VentsFramingClearance to CombustiblesMantle Clearances and Enclosures15 ELECTRICAL CONNECTIONHard Wiring ConnectionsSchematic16 FINISHINGDoor RemovalLog Shipping BracketLog PlacementGlowing Embers17 BLOWER REPLACEMENTNight Light™ Replacement18 DECORATIVE BRICK PANELINSTALLATION19 AFK / WI FACE KITINSTALLATION20 REMOTE AND VALVE ACCESSBurner Assembly RemovalBattery Replacement21-26 OPERATION / MAINTENANCEFireplace OperationHand Held Remote OperationOperating Instructions286 ADJUSTMENTSPilot Burner AdjustmentVenturi Adjustment27-28 REPLACEMENTSOrdering Replacement PartsReplacement PartsTerminal KitsVent KitsAccessories29-33 TROUBLE SHOOTING GUIDEWARNING• Do not burn wood or other materials in this fireplace.• Adults and especially children should be alerted to the hazards of high surface temperatures and should stay away to avoid burns orclothing ignition. Supervise young children when they are in the same room as the fireplace.• Clothing or other flammable material should not be placed on or near the fireplace.• Due to high temperatures, the fireplace should be located out of traffic and away from furniture and draperies.• Ensure you have incorporated adequate safety measure to protect infants/toddlers from touching hot surfaces.• Even after the fi replace is out, the glass and/or screen will remain hot for an extended period of time.• Check with your local hearth specialty dealer for safety screens and hearth guards to protect children from hot surfaces. Thesescreens and guards must be fastened to the floor.• Any safety screen or guard removed for servicing must be replaced prior to operating the fireplace.• It is imperative that the control compartments, burners and circulating blower and its passageway in the fireplace and venting systemare kept clean. The fi replace and its venting system should be inspected before use and at least annually by a qualified service per-son. More frequent cleaning may be required due to excessive lint from carpeting, bedding material, etc. The fi replace area must bekept clear and free from combustible materials, gasoline and other flammable vapours and liquids.• Under no circumstances should this fireplace be modified.• This fireplace must not be connected to a chimney flue pipe serving a separate solid fuel burning appliance.• Do not use this fireplace if any part has been under water. Immediately call a qualified service technician to inspect the fireplace andto replace any part of the control system and any gas control which has been under water.• Do not operate the fireplace with the glass door removed, cracked or broken. Replacement of the glass should be done by alicensed or qualified service person.• Do not strike or slam shut the fireplace glass door.• This fireplace uses and requires a fast acting thermocouple. Replace only with a fast acting thermocouple supplied by Wolf SteelNOTE: CHANGES, OTHER THAN EDITORIAL, ARE DENOTED BY A VERTICAL LINE IN THE MARGIN.TABLE of CONTENTSPLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE