Napoleon Park Avenue GD82NT-PA Installation And Operating Instructions Manual

Also see for Park Avenue GD82NT-PA: Installation and operation instructions Installation and operating instructions

Contents

Napoleon Park Avenue GD82NT-PA Installation And Operating Instructions Manual Manual pdf 36 page image

36W415-0748 / 12.12.087.2.1 Optional Front RemovalPull on the top of the optional front away from thefireplace until the male portion of the latchdisengages. Tilt forward slightly and lift from the 4shoulder screws (if installed).7.2.2 Control Panel RemovalTilt control panel away from the door and lift fromslots.7.2.3 Turn Power and Gas off to the unit.7.2.4 Door Removal. See “DOOR REMOVAL” section.7.2.5 Burner RemovalStart by removing the logs being careful since thelogs may still be warm. Remove the 2 screws holdingthe air deflector then remove the 3 screws holdingthe burner. Lift burner from firebox.7.2.6 Remove the 5 screws securing the burner base. Once the gas has been disconnected, the valve trainassembly will lift out. Service components as required.REMOVE 4 SCREWSBLOWERMOUNTING PLATEREMOVE 2 SCREWSBURNERBASEAIRDEFLECTORBURNER7.0 SERVICING / REPLACEMENTS7.1 BLOWER REPLACEMENTYour comes equipped with a heat circulating blower. The bloweris pre-wired and is controlled by the remote control supplied with the unit.Drywall dust will penetrate into the blower bearings, causing irreparabledamage. Care must be taken to prevent drywall dust from coming into contactwith the blower or its compartment. Any damage resulting from this conditionis not covered by the warranty policy.7.1.1 Turn off the power to the fireplace.7.1.2 Turn off the gas valve.7.1.3 Remove the glass door, logs, rear log supports, brick panels, airdeflector, burner assembly, panel support, panel support bracket.7.1.4 The blower mounting plate can now be removed. Remove the fourscrews that secure the plate to the firebox base.7.1.5 The blower is secured to the firebox. Disconnect the wire connectorsbefore attempting to remove the blower from the firebox.7.1.6 Remove the two screws securing the blower and lift through bloweraccess opening.NOTE: When re-installing the replacement blower, it will be necessaryto replace the gasket (W290-0104) on the blower mounting plate.7.2 BURNER AND VALVE REPLACEMENTFIGURE 7.1.4FIGURE 7.1.6FIGURE 7.2.5FIGURE 7.2.6! WARNINGRisk of fire and electrical shock.Turn off the gas and electrical power before servicing this fireplace.! WARNINGBe careful not to tear the burner train gasket. A replacement gasket can be ordered from your localauthorized dealer.