Napoleon Park Avenue GD82NT-PA Installation And Operating Instructions Manual

Also see for Park Avenue GD82NT-PA: Installation and operation instructions Installation and operating instructions

Contents

Napoleon Park Avenue GD82NT-PA Installation And Operating Instructions Manual Manual pdf 42 page image

42W415-0748 / 12.12.089.0 OPERATING INSTRUCTIONSWHAT TO DO IF YOU SMELL GAS:LIGHTING INSTRUCTIONSTO TURN OFF GASWhen lit for the first time, the fireplace will emit an odor for a few hours. This is a normal temporary condition caused by the "burn-in"of paints and lubricants used in the manufacturing process and will not occur again. After extended periods of non-operation such asfollowing a vacation or a warm weather season, the fireplace may emit a slight odor for a few hours. This is caused by dust particlesin the heat exchanger burning off. In both cases, open a window to sufficiently ventilate the room.A. This fireplace is equipped with a pilot which must be lit by hand while following these instructions exactly.B. Before operating smell all around the fireplace area for gas and next to the floor because some gas is heavier than airand will settle on the floor.C. Use only your hand to turn the gas control knob. Never use tools. If the knob will not turn by hand, do not try to repairit. Call a qualified service technician. Force or attempted repair may result in a fire or explosion.D. Do not use this fireplace if any part has been under water. Immediately call a qualified service technician to inspectthe fireplace and replace any part of the control system and any gas control which has been under water.• Turn off all gas to the fireplace.• Open windows.• Do not try to light any appliance.• Do not touch any electric switch; do not use any phone in your building.• Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.• If you cannot reach your gas supplier, call the fire department. GAS KNOBDo not connect valve or wall switch to electricity. See installation instructions.When lighting and re-lighting, the gas knob cannot be turned from pilot to off unless the knob it depressed slightly.1. STOP! Read the safety information on the operating label.2. Turn off all electric power to the fireplace.3. Turn the gas knob clockwise to off.4. Wait 5 minutes to clear out any gas. If you smell gas, including near the floor, STOP! Follow “B” on the operating label. Ifyou don’t smell gas, go to the next step.5. If the fireplace is equipped with a flame adjustment valve, turn clockwise to off.6. Find pilot located in front of the back log on the right.7. Turn gas knob clockwise to pilot.8. This unit is equipped with an auto-spark. Depress and hold gas knob. Keep knob fullydepressed for one minute, then release. If pilot does not continue to burn repeat steps 3through 7.9. With pilot lit, push and turn gas knob counter-clockwise to on.10. If equipped with flame adjustment valve, turn knob to high.11. If equipped with remote on-off switch, main burner may not come on when you turn the valveto on or high. Remote switch must be in the on position to ignite burner.12. Turn on all electric power to the fireplace.TURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THE FIREPLACE.1. Turn off all electric power to the fireplace if service is to be performed.2. For a complete shut-down procedure: push in gas control knob slightly and turn clockwise to off. Do not force.3. For a temporary shut-down procedure: set the switch to off. Press and turn the gas knob clockwise to pilot.ON/OFFKNOBPILOTSOLENOIDFOR YOUR SAFETY READ BEFORE LIGHTING:37.2FIGURE 9.0