WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approvedwith this appliance may result in property damage or personal injury.CAUTION: Before proceeding with conversion the gas supply must be shut off prior to disconnecting the electrical power.1. Remove the media from the appliance.2. Remove the two screws securing the burner assembly in place (FIG. 1). Lift the assembly up and out of the appliance.3. Remove the two screws securing the orifice bracket in place (FIG. 2).4. Using a deep socket wrench, remove the orifice from the bracket. A back up wrench must be used on the manifold, located behindthe orifice bracket, to ensure the flex does not twist or kink. Using a pipe thread compound, replace with the orifice supplied (#32 forNG, #48 for P).This conversion kit shall be installed by a qualified service agency in accordance with themanufacturer’s instructions and all applicable codes and requirements of the authority havingjurisdiction. If the information in these instructions is not followed exactly, a fire, explosionor production of carbon monoxide may result causing property damage, personal injury orloss of life. The qualified service agency is responsible for the proper installation of this kit.The installation is not proper and complete until the operation of the converted appliance ischecked as specified in the owner instructions supplied with the kit.FUEL CONVERSION KITS FOR MODELGSS36CFThese kits are for use at altitudes of 0 to 4500 feet.INSTALLER: THESE INSTRUCTIONS ARE TO REMAIN WITH THE HOME OWNER.CHECK THE BOXES TO INDICATE THAT THE CORRESPONDING STEPS HAVE BEEN COMPLETED.Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 0G8 Canada • 1(866)820-8686 • www.napoleonfireplaces.comW175-0682, Propane to Natural Gas Includes:REGULATOR 1#32 BURNER ORIFICE 1CONVERSION DATA LABEL 1NATURAL GAS PILOT INJECTOR 1W415-1832 / A / 04.13.186. Remove the two screws from the valve regulator, remove the regulator, and replace with the one supplied.7. Remove the pilot hood from the pilot assembly by removing the retaining clip and pulling vertically. (NOTE: youwill need to bend the pilot shield up to be able to remove the pilot hood). Use a 5/32” Allen key tounscrew the injector. Replace the pilot injector with the one supplied. Re-assemble the pilot hood onto theassembly, ensuring key position for proper alignment. Reinstall retaining clip.8. Fill out the conversion data label and attach adjacent to the valve.9. Re-install the orifice bracket, ensuring the burner fits over the burner orifice, then reinstall the burner assembly.10. Turn on the gas supply, then light the pilot (refer to the lighting instructions in your installation manual) to ensurethe gas lines have been purged.11. Check for gas leaks by brushing on a soap and water solution. Do not use open flame. Once all systems havebeen checked, replace the media.PILOTHOODPILOTINJECTORSPRINGCLIPFIG. 1: Back View of Burner AssemblyW175-0681, Natural Gas to Propane Includes:REGULATOR 1#48 BURNER ORIFICE 1CONVERSION DATA LABEL 1PROPANE GAS PILOT INJECTOR 1Air Shutter5. Prior to reinstalling the burner assembly, ensure to adjust the air shutter (FIG. 3). Refer to the venturi adjustment chart on thefollowing page for details.FIG. 2: Side/Back View of Burner Assembly FIG. 3: Under Side View of Burner