National Instruments PXIe-1092 User Manual

Also see for PXIe-1092: Installation guide CALIBRATION PROCEDURE

Note Refer to your module user manual for specific instructions and warnings.The following section contains installation instructions for installing a multiple-slot wideperipheral module that expands to the right in a PXIe-1092 chassis utilizing the peripheralexpansion slot. To install a multiple-slot module, complete the following steps:1. Connect the AC power source to the PXI Express chassis before installing the module.The AC power cord grounds the chassis and protects it from electrical damage while youinstall the module.2. Power off the chassis.3. Remove the cover panel from the peripheral expansion slot.4. Inspect the slot pins on the chassis backplane for any bending or damage prior toinstallation. Do not install a module if the backplane is damaged.5. To prevent damage to the chassis, ensure that you are installing the multiple slotperipheral module in the correct type of slot. Refer to the PXIe-1092 Backplane Overviewsection for the slot descriptions.6. Install the module in the chassis by aligning the module so that the right-most portion ofthe multiple-slot peripheral module will occupy the slot peripheral expansion slot.7. When you begin to feel resistance, push up on the injector/ejector handle to seat themodule fully into the chassis frame. Secure the module front panel to the chassis usingthe module front-panel mounting screws.Note Do not install a single-slot wide peripheral module in theperipheral expansion slot as it will not be functional.Figure 12. Installing a Multiple-Slot Module Utilizing the Peripheral Expansion SlotCOOLING CLEARANCES REQUIRED. SEE MANUAL.PXIe-10929HHH321PS TEMP FANSUSE ONLY COMPATIBLE RACK MOUNT KITS.COOLING CLEARANCE REQUIRED. SEE MANUAL.COOLING CLEARANCES REQUIRED. SEE MANUAL.PXIe-10929HHH321PS TEMP FANSUSE ONLY COMPATIBLE RACK MOUNT KITS.COOLING CLEARANCE REQUIRED. SEE MANUAL.PX Ie-839xMXI-ExpressPX Ie-6570100 MHz Digital Pattern Instrument with PPMUPXIe-1092 User Guide | © National Instruments | 21