16Water TempHigh Parking BrakeOil Pressure F Water in FuelLowG Glow Plugs OnBattery4.3—HOUR METERThe hour meter (2,Fig. J) indicates the number of hours thetractor has been operated. It can be used to keep track ofmaintenance intervals and the amount of time required toperform various tasks. The hour meter operates whenever theignition key is in the “on” position.Your I-Trim Mower maybe equipped with a digital hour meter.This meter will display a signal after 5 hours and every 25hours thereafter, recommending that you perform maintannceland lubricate the mower. (see sec.7). The display willautomaticly reset after 2 additional hours of run time.4—CONTROLS4.1—IGNITION SWITCHInsert key in switch (1, Fig.J) and turn clockwise to onposition and wait until the glow plug light turns off. After lightturns off, turn key clockwise as far as it will go to start engine,then release. The deck rotation control switch must be in theoff position, the traction control pedal in the neutral positionand a operator must be sitting on the seat before startingengine.Do not hold key in “ON” position more than 15 second at atime.Key should be removed when tractor is not in use to preventunauthorized operation.Refer to section “5.2” for complete starting information.4.2—INDICATOR LAMPSAfter engine is started, illumination of any indicator lamp willindicate a problem (3, Fig J). Stop engine and correctproblem.When Key is turned to “ON” the Battery Charging, Glow PlugON, and the Oil Pressure indicator lamps should illuminate.After 5 seconds, the Glow Plug ON light should turn off (FigK).NOTE: The water temperature light will start flashing at 200deg F. Decks will shut off at 220 deg F. Engine will shutdown at 230 deg F.FIGURE J12437FIGURE K5 68109