The Touch Auto-write option is also available on the KOMPLETE KONTROL S-SERIESkeyboards. See section Using the Touch Strips for more information.Example of UseTouch Auto-write can be very handy if a parameter already has some modulation recorded inthe Pattern, and you want to re-record modulation for this parameter, this time at a constantvalue:▪ With Touch Auto-write disabled (and in previous MASCHINE versions), you have to con-stantly rotate the Knob to ensure that the old modulation events are actually replaced bythe new ones. To simulate a new constant modulation value, you had no other choice thanslightly rotate the Knob incessantly around the desired value.▪ With Touch Auto-write enabled, you just need to keep a finger on the Knob: The currentmodulation value is recorded in new modulation events as long as you touch the Knob, au-tomatically replacing any old modulation events at these positions.2.6.8.4 Zoom and Scroll OverlaysSince MASCHINE 2.0, when your MASCHINE STUDIO controller is in particular modes, youcan use Knob 5 and 6 to respectively zoom and scroll horizontally through the content shownin the right display. In some cases (e.g., in Keyboard mode) you can additionally use Knob 7 toscroll vertically through this content.In MASCHINE 2.2, the zooming and scrolling functions are indicated, when available, by littleicons that appear as overlays above the relevant Knobs as soon as you touch any of them. Thisway, in case of doubt, a simple touch on any Knob below the right display will indicate if somezooming and scrolling functions are available.Basic ConceptsPreferencesMASCHINE STUDIO - Manual - 100
