9.5.2 Adjusting the Level and Pan in Mix ModeThe Mix mode allows you to quickly adjust the level and panoramic position of each of yourchannels via Knobs 1–8. To do this:1. If you want to adjust the level and panoramic position of Groups, switch to the Group viewby pressing BACK under the jog wheel.2. If you want to adjust the level and panoramic position of Sounds, switch to the Soundview by pressing ENTER under the jog wheel or by pressing the jog wheel itself.3. Use the Page buttons to show the desired channels on the displays. You can also use theGroup buttons and pads of your controller to directly switch to the desired channel.4. Press the FUNCTION buttons under the jog wheel to select either the level or the panor-amic position parameter.At the bottom of the displays, the selected parameter appears under each channel strip.5. Turn the desired Knob(s) 1–8 to adjust the displayed parameter in the correspondingchannel(s). You can also use the jog wheel to adjust that parameter for the focused chan-nel.As usual you can hold SHIFT while turning Knobs 1–8 (or press the jog wheel whileturning it) to make finer adjustments.In each channel strip the peak value is indicated above the level meter. This peak value is re-set each time you start the playback via PLAY or RESTART on your controller, or when youclick the corresponding peak value in the software’s Mixer (see section ↑9.2.5, Adjusting Set-tings in the Channel Strips).9.5.3 Mute and Solo in Mix ModeWhen your controller is in Mix mode, pressing MUTE or SOLO doesn’t switch the displays tothe usual Mute or Solo mode: In addition to the usual procedure to mute or solo Groups andSounds, you can mute or solo your channels directly in Mix mode. To do this:► To mute a channel in Mix mode, press MUTE + the Button 1–8 above the desired chan-nel(s).Controlling Your MixControlling Your Mix from Your ControllerMASCHINE STUDIO - Manual - 528
