13© by N&W GLOBAL VENDING SpA 07 06 275- 00INSTALLING THE PAYMENT SYSTEMThe machine is sold without payment system, there-fore the installer of such a system is responsible forany damage to the machine or to things and personscaused by faulty installation.Payments systems such as validators, “change-giver” and“cashless” can be installed by using the specific kits.Payment systems such as “change giver” must be physi-cally housed in the special side module (optional).WATER SOFTENER UNITThe machine is sold without water softener.Should the mains water be very hard, a 2-litre ion-ex-change resin water softener unit can be installed in thecabinet.The water softener, available as accessory, must be re-placed or regenerated regularly following the directions fromthe manufacturer.For health and functional reasons, higher capacity watersoftener units should not be used.In the event of water supply from the tank, the specialfiltering cartridges can be used.The cartridges must be replaced periodically according tothe water quality and to the instructions from the manufac-turer.INSERTING THE PRODUCT LABELSThe menu and instruction labels are supplied with themachine and must be inserted at the time of installationaccording to the layout and to the language (see “selectiondose” table).To access the label insertion slots, completely undo thetwo knurled nuts at the back of the door and remove thecover. Disconnect the key-pad cables from the push-button board and remove the label support, sliding out thetabs from the slots on the door (see fig. 18). Insert thelabels in the appropriate slots and reassemble everythingin the reverse order.POWER ONBefore switching the machine on, ensure that the groundstrays and the container lids are into place.Each time the machine is switched on, the display showsthe following message:REV 1.0POWER ONConfirm?Press any selection button to continue.It is possible to program the machine to enable the functionthat displays the controls to be performed before startingthe machine, and namely:Tubing (nozzles etc.)MixersPowder feederPower onFor all controls the request “Confirm?” is indicated on thedisplay.Press any selection button to continue.The function of presenting the list of preliminary controlscan be enabled (disabled by default) from the program-ming menu.At the end of the power on cycle, the display indicates thesoftware version number, present on the CPU board andon the control board of the brewer unit.Press any selection button to continue.SELECT THE DRINKThe machine can be programmed for displaying, for a fewsecond, the number of selections made.After a few seconds the display shows the message:Controller FBREV 1.0Fig. 181 - Cover2 - Fastening screws3 - Keypad cables4 - Label support5 - Label support tabs6 - Slots for inserting the labels