17-2TA6530 EmulationMake the relevant selections then click OK to return to the Host Informationdialog box, then click Next to display the Advanced Options dialog box.6. Click Finish to return to the Terminal Connection Manager.7. In the Terminal Connection Manager, display the Connections list, select thesession name you specified earlier in step 3, then click the Connect button.The Tandem 6530 emulation is configured using the TA6530 Settings dialog boxwhich is described in the Setup Menus chapter.Non-WBT ModeThis section describes the basic procedure for creating a session configuration whenthe terminal is not in WBT mode. The options available are described in detail in theSetup Menus chapter.1. Display the Settings menu from the command bar and select Emulation... todisplay the Emulation Settings dialog box.2. Select the TA6530 terminal emulation in the Alpha Emulation list box.3. Display the File menu from the command bar and select New Connection todisplay the New Connection dialog box.4. Select the type of host connection required in the Type list box.For a TCP/IP connection, select TCP/IP, enter the name or internet address ofthe host computer in the Connect To box, then click Configure for additionalTelnet options. Refer to the TCP/IP Connection Settings section in chapter 2 fordetails.For a modem connection, select Modem, specify the communications port in theConnect To box, then click Configure to display configuration options. Refer tothe Modem Connection Settings section in chapter 2 for details.For a serial connection, select Serial, specify the communications port in theConnect To box, then click Configure for additional serial options. Refer to theSerial Connection Settings section in chapter 2 for details.5. When you have specified the required settings in the New Connection dialogbox, click the Connect button to make the connection.Note: You can save these settings as a connection template usingthe Save Session As dialog box. Refer to the Setup Menuschapter for details.The Tandem 6530 emulation is configured using the TA6530 Settings dialog boxwhich is described in the Setup Menus chapter.
