WAN and System Configuration 8-351. Select Current Date and enter the date in the appropriate format. Use one- or two-digit numbers for themonth and day, and the last two digits of the current year. The date’s numbers must be separated byforward slashes (/).2. Select Current Time and enter the time in the format HH:MM, where HH is the hour (using either the12-hour or 24-hour clock) and MM is the minutes.3. Select AM or PM and choose AM or PM.Note: If you have Connection Budgets configured, changing the date setting will reset the Connection Budgetsunder one of the following conditions:If the new date is greater than the old date and the new date falls outside of the current budget window; or, ifthe new date is in the past and the date is not the current date (i.e. yesterday or earlier). A warning message isdisplayed in the console window when a budget is reset.See “Connection Budgets page” on page 12-26 for more information.CCCCoooonnnnssssoooolllleeee ccccoooonnnnffffiiiigggguuuurrrraaaattttiiiioooonnnnYou can change the default terminal communications parameters to suit your requirements.To go to the Console Configuration screen, select Console Configuration in the System Configuration screen.Follow these steps to change a parameter’s value:1. Select the parameter you want to change.2. Select a new value for the parameter. Return to step 1 if you want to configure another parameter.3. Select SET CONFIG NOW to save the new parameter settings. Select CANCEL to leave the parametersunchanged and exit the Console Configuration screen.Console ConfigurationBaud Rate... 57600Hardware Flow Control: NoSET CONFIG NOW CANCEL