NeuraLabel 300x User Guide30© 2015 NeuraLabel Printing Solutions, A Neuralog CompanyKeep pushing gently until you feel a bump where the media hits the back wall (about 5inches). The red arrow in the following illustration of the inside of the printer indicateshow the media should be loaded.NOTE: The media will slide about 5 inches into the printer Tray 1 opening.Figure: Printer Paper PathAt this position the media is properlypositioned to begin printing.STEP 3. Jog the media through the printer (optional).Once the media is loaded, you can begin printing immediately. You can optionally “jog”the media through the printer in small increments by tapping the jog button, or, holdingthe button down to jog continuously. If the jog button light on the operator panel is lit, thenyou can jog the media forward.Figure: Jogging thePrinter MediaPress the jog button on the operator panel, either in briefincrements or steadily. Note that the media can only travelin a forward direction.Figure: Jog Button3.4.2 Loading Rolled MediaRolled media, whether continuous un-diecut, or pre-diecut, is loaded into the printer thesame way as fan-fold media. Rolled media tends to be curled more at the edges thanpre-diecut fan-folded. Take care with inserting the media into the printer properly so thatit doesn’t jam when you try to print.STEP 1. Position media in Tray 1 (Continuous Tray) opening.
