NightStick 4620 Instructions Manual

NightStick 4620 Instructions Manual Manual pdf 1 page image

BAYCO • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • www.baycoproducts.comModel 4620 / 4622 Flashlight InstructionsMultiple Patents PendingINS-4620-12CAUTION: DO NOT use in explosive atmospheres, near flammable liquids,or where explosion proof lamps are requiredDO NOT use in the proximity of vehicles or equipment when there is a risk of flammableliquids coming into contact with the hand-lampCAUTION: For Light Duty Use OnlyWARNING: NOT FOR USE ABOVE HAZARDOUS LOCATIONSThank you for purchasing this Nightstick flashlight. Save these instructions.Please read these instructions before using your flashlight.INSTALLING BATTERIES1. Remove the battery compartment cap located on the bottom of the flashlight. Unscrewthe cap by using a coin or similar shaped tool by inserting the coin into the cap slotand rotating counter-clockwise until the cap separates from the flashlight body.2. Insert the batteries as shown in the illustration. Observe the correct polarity of thebatteries.3. Insert the battery cap back into the light and tighten the cap using the coin, turn in aclockwise direction.4. The flashlight is now ready for use.BATTERY NOTES Batteries may lose power when stored for long periods. Alkaline batteries can leak and cause corrosion if stored for long periods. Alwaysremove batteries if the light will be unused for extended periods. Batteries should be stored between 68-78°F (20-25°C)SAFETYCAUTION BRIGHT LED RADIATION: AVOID DIRECT EYE EXPOSURE. The light is aClass 2 LED product per IEC 60825-1 Edition 1.2.2001. Do not use this FLASHLIGHT in explosive or hazardous areas.O-RING MAINTENANCE1. O-rings should be cleaned with a soft clean cloth to insure that the sealing area is freeof dirt, dust or foreign matter that could destroy the waterproof seal.2. Apply a light coat of clear silicone grease on the O-ring to extend the life of the O-ring.OPERATIONBoth models have two body switches that control the flashlight and the floodlight. Theflashlight and floodlight functions can be operated independently and together.1. The upper switch controls the flashlight. Lightly press the switch for momentaryflashlight operation. For constant on, press the switch until it clicks. Press again foroff.2. The lower switch controls the floodlight. Press for full power. Press again for half-power. Press again to turn off.3. For dual-light (flashlight & floodlight) operation, press the flashlight and the floodlightbuttons.IMPACT BUMPERS & CLIP MAGNETInstall the orange impact bumpers on the top and bottom of the flashlight. The closedbumper goes on the bottom of the flashlight.For hands-free lighting attach the clip-magnet to the flashlight body.WARRANTYLimited Lifetime WarrantyProduct is warranted to be free from defects in workmanship and materials for thelifetime of the original owner. Includes the housing, lenses, electronics and switches.Batteries, normal wear and abuse are excluded.Not CoveredConsequential damages, incidental damages or incidental expenses, including damageto property. Some states do not allow the exclusion or limitation of incidental orconsequential damages, so the above limitation or exclusion may not apply to you. Thiswarranty gives you specific legal rights, which may vary from state to state.Warranty Claims - USAContact Bayco for USA warranty claims. Call 800-233-2155 or emailcs@baycoproducts.com and Bayco Customer Service will provide a Return GoodsAuthorization (RGA) to facilitate rapid warranty action. After receiving the RGA, send theproduct (shipping prepaid) to BAYCO • 640 S. SANDEN BLVD • WYLIE, TEXAS • 75098.Include a dated proof of purchase and a brief description of the defect with your name,address and phone number. Your product will either be repaired or replaced at the optionof Bayco and returned as soon as practical, but no later than 45 days after beingreceived by Bayco.Warranty questions and international claimsIf you live outside the USA or have questions about this warranty or an inquiry aboutother Bayco products contact BAYCO • 640 S. SANDEN BLVD • WYLIE, TEXAS • 75098or call 800-233-2155Instructions Modèle Lampe de poche 4620/4622Brevets multiples en attenteATTENTION: NE PAS utiliser des lampes dans des atmosphères explosives, à proximitéde liquides inflammables, ou lorsque l'épreuve des explosions sont nécessairesNE PAS utiliser à proximité de véhicules ou d'équipement quand il ya un risque deliquides inflammables d'entrer en contact avec la main-lampeATTENTION: Pour Light Duty Utilisez uniquementAVERTISSEMENT: NE PAS UTILISER POUR CI-DESSUS DES ENDROITSDANGEREUXMerci d'avoir acheté cette lampe de poche Nightstick. Conservez ces instructions.S'il vous plaît lire attentivement ces instructions avant d'utiliser votre lampe de poche.INSTALLATION DES PILES1. Retirez le couvercle du compartiment à piles situé sur le bas de la lampe de poche.Dévisser le bouchon à l'aide d'une pièce ou un outil similaire en forme par l'insertionde la pièce dans la fente capuchon et en rotation anti-horaire jusqu'à ce que lebouchon se sépare du corps lampe de poche.2. Insérez les piles comme indiqué dans l'illustration. Respectez la polarité des piles.3. Insérez le capuchon de la pile de retour dans la lumière et serrer le bouchon à l'aidede la pièce, tournant le sens horaire.4. La lampe de poche est maintenant prêt à l'emploi.REMARQUES SUR LA BATTERIE Les batteries peuvent perdre de la puissance lorsqu'il est stocké pendant de longuespériodes. Les piles alcalines peuvent fuir et provoquer la corrosion s'il est stocké pendant delongues périodes. Toujours retirer les piles si la lumière ne sera pas utilisée pendantde longues périodes.

/ 2

Related manuals for NightStick 4620