NightStick NSP-4608 Instruction Manual
Also see for NSP-4608: Instruction manual
Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • 1-469-326-9400 • www.nightstick.comINS-NSP-4608_4610-21Instruction ManualNSP-4608/4610US PATENT 9,713,217Please read these instructions before using this product. They includeimportant safety and operation information.WARNINGSy NOT FOR USE ABOVE HAZARDOUS LOCATIONSy DO NOT use in explosive atmospheres, near fl ammable liquids, or whereexplosion proof lamps are required.y DO NOT use in the proximity of vehicles or equipment when there is a risk offl ammable liquids coming into contact with the flashlight.y DO NOT expose the batteries to water or salt water, or allow the batteries toget wet.y DO NOT store the batteries with metallic objects that may cause a short circuit.y Immediately discontinue use of the batteries if they emit an unusual smell, feelhot, change color, change shape or appear abnormal in any way.y Keep out of the reach of children.INSTALLING BATTERIESy Unscrew the battery compartment door on the back of the headlamp.y Insert the batteries per the outline inside the battery compartment. Observe thecorrect polarity of the batteries.y Close the battery door and fasten the battery compartment door screw.y The headlamp is now ready for use.OPERATIONTwo switches control all functions on both models.NSP-4608 SPOTLIGHT SWITCHy First Press = spotlight high-brightnessy Second Press = spotlight low-brightnessy Third Press = offNSP-4608 FLOODLIGHT SWITCHy First Press = floodlight high-brightnessy Second Press = floodlight low-brightnessy Third Press = offNSP-4610 SPOTLIGHT SWITCHy First Press = spotlight high-brightnessy Second Press = spotlight low-brightnessy Third Press = white floodlighty Fourth Press = offNSP-4610 FLOODLIGHT SWITCHy First Press = red floodlighty Second Press = green floodlighty Third Press = offBATTERY SHUT OFF MODEy Press and hold both switches at the same time for 3 seconds to enable ordisable battery shut off mode.y After three seconds the light will fl ash on and off 1 time to confirm a change inthe battery safe mode.NOTE: The battery safe mode reverts to disabled when batteries are removedor fully discharged.WARRANTYLIMITED LIFETIME WARRANTYBayco Products, Inc. warrants this product to be free from defects in workmanshipand materials for the original purchaser’s lifetime. The Limited Lifetime Warrantyincludes the LEDs, housing and lenses. Rechargeable batteries, chargers, switches,electronics and included accessories are warranted for a period of two years withproof of purchase. Normal wear and failures which are caused by accidents, misuse,abuse, faulty installation and lightning damage are excluded.We will repair or replace this product should we determine it to be defective.This is the only warranty, expressed or implied, including any warranty ofmerchantability or fitness for a particular purpose.For a complete copy of the warranty, go to www.baycoproducts.com/bayco-product-support/warranties. Retain your receipt for proof of purchase.Mode d’emploiNSP-4608/4610Veuillez lire ces instructions avant d’utiliser ce produit. Elles comprennent desinformations importantes liées à la sécurité et à l’utilisation de ce produit.AVERTISSEMENTSy NE PAS UTILISER AU-DESSUS D’ENDROITS DANGEREUX.y NE PAS utiliser ce produit dans une atmosphère explosive, à proximité deliquides inflammables, ou dans des endroits exigeant un éclairage antidéflagrant.y NE PAS utiliser ce produit à proximité de véhicules ou d’équipement quand desliquides inflammables pourraient entrer en contact avec la lampe torche.y NE PAS exposer les batteries à l’eau ou à l’eau salée, et ne pas laisser lesbatteries se mouiller.y NE PAS ranger les batteries à proximité d’objets métalliques qui pourraientcauser un court-circuit.y Arrêtez immédiatement d’utiliser les batteries si elles émettent une odeurinhabituelle, sont brûlantes au toucher, changent de forme, ou en cas de touteautre anomalie.y Ne pas laisser pas à la portée des enfantsINSTALLATION DES PILESy Dévissez le couvercle du compartiment de la batterie à l’arrière du projecteur.y Insérez les piles par le contour à l’intérieur du compartiment à piles. Respectezla polarité des piles.y Fermez la porte de la batterie et serrez la vis de la porte du compartiment à piles.y Le projecteur est maintenant prêt à être utilisé. |
Related manuals for NightStick NSP-4608
NightStick NSP-4608B Instruction Manual
NightStick NSP-4604B Instruction Manual
NightStick NSP-4610 Instruction Manual
NightStick NSP-4650B Instruction Manual
NightStick NSP 1162 Instruction Manual
NightStick NSP 1170 Instruction Manual
NightStick NSP-2422R Instruction Manual
NightStick NSP-9842XL Instruction Manual
NightStick FORGE NSP-4640B Instruction Manual
NightStick 4620 Instructions Manual
manualsdatabase
Your AI-powered manual search engine