133Wireless Transfer ModeUsing the Wireless Transfer ModeThe following conditions and preparations are required to use the Wireless trans-fer mode (c134).Requirements for Using the Wireless Transfer ModeWireless LAN Environment (IEEE802.11b/g Compatible)Set up the following devices or environment.• When making a peer-to-peer connection between the camera and computer(Ad-hoc mode):Set up a computer with an internal orexternal wireless LAN adapter.• When making a connection via an access point (Infrastructure mode):Set up a wireless LAN environmentusing a wireless LAN access point.Check that the computer which willreceive the images is connected tothe wireless LAN network.Operating Systems that Support Wireless Transfer ModeOperations of the Wireless transfer mode are confirmed for the following operat-ing systems:• Windows XP Professional/Home Edition (SP1 or later; SP2 is recommended)• Mac OS X (10.3 or later)The latest information on supported operating systems is available on the NikonWeb site listed in Life-Long Learning (c1).Software for Setting up Profile Information in the Camera• Wireless Camera Setup Utility (hereafter referred to as the Setup Utility)The Setup Utility sets the profiles and wireless LAN environment information inthe camera. If this is not set properly, the camera cannot connect to the wirelessLAN. The “Wireless Camera Setup Utility/PictureProject Installer CD“ (hereafterreferred to as the CD-ROM) supplied with the camera is required for installation.Wireless LAN environmentFor further information about wireless LAN environment, contact the manufacturer of thewireless LAN adapter or the access point for the wireless LAN, or refer to the commercialguidebook.
